Не е лошо ,за в бъдеще да се чете повече като се пускат такива теми
. Като за начало не става дума за RECALL ,а за safety check .
Още по накратко "пина" който държи лостчето трябва да е стегнат в определените от производителя параметри 2нм за алуминиеви, 1 нм за карбонови лостчета /разгледайте пдф-а по-долу/
Официално изявление на Ханглийски:
..........................................................................
Press Release
FORMULA BRAKE informs
Important Safety Check on ORO Brakes!
FORMULA in-house tests have shown that on a certain production run of FORMULA ORO disc brakes it is possible, in the worst case, that the grub screw which secures the lever pivot on Formula Oro brakes may become loose and allow the lever pivot to become detached. This could lead to a total failure of operation and complete loss of braking.
The brakes affected are all ORO systems with serial numbers below 295236 (manufactured before the 1st of June 07).
Please contact your dealer immediately to arrange a quick and simple safety check for your Oro system.
For any further question please check the following link http://www.formula-brake.it/pdf/safety/Grano.en.pdf
Or contact directly our distributor in your country
http://www.formula-brake.it/index2.htm
.............................................................................................
В понеделник ще бъде публикувано тук и в сайта на БГ с повече обяснения и картинки. А вие докато се тюхкате, аз отивам да ги карам тия спирачки.